Labo Peel Spicule Renewal Program

1. STEAMER

Position the steamer about 16 inches (approximately 40 cm) away from the face and décolleté (neckline and upper chest).

2. RICH CLEANSING MILK (First Cleanse)

Pump 2–3 times and gently massage over the entire face in rolling motions.

3. RICH CLEANSING MILK (Remove)

Wipe away any remaining cleansing residue with a sponge.

4. RICH BUBBLE CLEANSER (Second Cleanse)

Apply evenly to the face using a mask brush and leave on for 3 minutes. Once oxygen bubbles form, gently rub with water and rinse off.

5. CLEANSING FINISH

Finish by wiping off with a sponge.

6. LABO PEEL (Booster and Powder)

Mix LABO PEEL Powder and Booster at a 1:0.5 ratio. Using a mask brush, apply a thin layer evenly over the entire face. Put on gloves and gently press with light techniques.

7. LABO PEEL (Booster)

After the drying process, place the enclosed cone cap on the remaining Booster, then gently apply once more and allow it to absorb.

8. CLEANSING FINISH

Apply HYDRO LUPINE GEL evenly over the entire face using a mask brush.

9. HYDRO LUPINE GEL

Using a mask brush, apply HYDRO LUPINE GEL evenly over the entire face.

10. HYDRATING TONER AND ESSENCE

1. Stretch and place the mummy pads soaked in HYDRATING TONER + ESSENCE. 2. Apply a thin layer of HYDRO LUPINE GEL over the mummy mask and leave it on for 10 Minutes.

11. HYDRO CARE CREAM

Apply HYDRO CARE CREAM generously over the entire face to form a white film.

*Be careful to avoid the eye and lip areas.

12. THE REAL CARE 2 STEP MODELING MASK

Mix the Step 1 Ampoule Gel with the Step 2 Powder, apply evenly over the entire face, and leave on for 10–15 Minutes

13. VIOLA TRICOLOR WATERDROP

Gently pat with your fingertips to help the product absorb into the skin.

14. HYDRO CARE CREAM

Apply HYDRO CARE CREAM generously over the entire face, allow it to absorb, and finish the treatment.